Electric Dog Fence Sod Staples - Pkg of 100

Want an electric dog fence but hate the thought of burying all that wire? Now you don't have to!

With our Electric Dog Fence Sod Staples, simply lay out the wire in your desired pattern and "staple" the wire to the ground. Our sod staples come in packages of 100.

Step 1:

• First run your twisted wire from your transmitter out to the beginning of your boundary.
• Now "Staple" the twisted wire to the ground by hammering in a wire "Staple" every 5 - 6 feet.
• Now stop and look at the wire. Is it completely flush to the ground all the way to the start of the boundary? If not go and "Staple" any raised areas before proceeding to the next step. The wire MUST completely touch the ground.

Step 2:

• Next, place a "Staple" where the twisted wire and the beginning of the boundary meet (if you have a splice in this area please dig a small hole about 2 inches deep and bury the splice.
• Then place a "Staple" in the front of and behind the splice to relieve any pressure on the splice)
• Now walk the wire to the first corner of your boundary and "Staple" it to the ground. Repeat this step for all four corners of your boundary.
• Next go back just as you did with your twisted wire and "Staple" any raised areas down until they are completely flush with the ground.

You have no need to worry about people tripping over the wire because it is completely flush to the ground and will be completely hidden within 7-10 days. You also do not need to worry about your lawnmower cutting the wire as the blades will never get anywhere near the wire. Nobody cuts their lawns to shorter than an inch, with the vast majority of people keeping them at 2" - 3" inches, the wire is flush to the ground and cannot be cut.


There are really only a couple of instances where burying the wire is preferable.

• If you are putting a fence into a pasture area where livestock such as horses or cattle will frequent, then you will want to bury the wire as their hooves will create breaks. In this case you will want the wire at least 8 - 10 inches underground.
• If you frequently have your yard aerated you will want the wire at least 5 - 6 inches in the ground. Although if you do an above ground installation you can simply avoid the exterior boundaries when performing the aeration.